Page 2 of 2

Re: Salmon and bacon using new cold smoke generator - q view

PostPosted: 07 Jan 2014, 13:09
by derekmiller
I would be interested in what you find.
We found a source of wood shavings and sawdust, we could take as much as we wanted for nothing, but it was a mixture of Oak (ok), Walnut (may be a bit strong, not sure of the mix ratio) and Tulipwood (?).
Not having any guarantee of how the wood had been handled, treated etc, we took it all down the dump.
At least with "smoking dust" you know the sawdust is food grade.

Re: Salmon and bacon using new cold smoke generator - q view

PostPosted: 07 Jan 2014, 14:37
by robgunby
This much is true Derek, and I'll only get dust from this mill if I can be satisfied of its purity.

The sawmill is in a hardwood woodland, with no softwood being produced or felled, so it's a good start! Unfortunately they are only open a few hours a week, and it's on the other end of town so I have to be picky with my timing!

Re: Salmon and bacon using new cold smoke generator - q view

PostPosted: 07 Jan 2014, 19:55
by YetiDave
I get mine from hotsmoked.co.uk

Re: Salmon and bacon using new cold smoke generator - q view

PostPosted: 07 Jan 2014, 20:25
by robgunby
That's a fair bit cheaper than the link Derek provided. Perhaps a backup for if I have no joy at the sawmill. Watch this space I will report back....

Re: Salmon and bacon using new cold smoke generator - q view

PostPosted: 07 Jan 2014, 20:50
by YetiDave
I've just sent an email to a place that I *think* will have a huge variety available. I'll let you know how it works out

Re: Salmon and bacon using new cold smoke generator - q view

PostPosted: 08 Jan 2014, 11:31
by derekmiller
Shows you need to keep checking prices.
12 months ago those prices were similar to Turans.
Now those bulk prices are certainly well worth it, 40% savings
Thanks Dave.
Might "Go compare" some of my other suppliers....

Re: Salmon and bacon using new cold smoke generator - q view

PostPosted: 24 Apr 2014, 09:38
by derekmiller
robgunby wrote:That's a fair bit cheaper than the link Derek provided. Perhaps a backup for if I have no joy at the sawmill. Watch this space I will report back....


Any news Rob?